OtterBox uniVERSE ELD Kit #100916 | How-To Install Samsung Galaxy Tab Active Pro By ProClip USA
Today we'll be installing Letterbox LD bundle number one: zero, zero, nine one, six for the Samsung Galaxy Tab active pro. The first part of the ELD kit that will be installing is the pedestal and backplate onto the dash. To do that, we are first going to determine our mounting location on this particular truck. It's going to be right on the side of the console. Then we need to remove the face plate from the dash to gain access to the inside of the dash panel behind our mounting location next you're, going to want to access the other side of the dash to determine if it is safe to drill the four holes if they are not already there, it's important to avoid drilling near any important, electronics or gauges to do this. You can remove one of the pedestal bases and use it as a template for drilling the holes.
Once the holes are drilled, we can use the same access point to add the backplate. Now that we've access to the back side of the dash we're going to want to put a screw into the pedestal base, then we want to put that through one of the pre-drilled holes and use it to line up the backplate inside the ? once the pedestal base and backplate are lined up, you can go ahead and add the rest of the screws and the lock nuts. Now we're going to use a seven millimeter wrench to hold the nuts in place. While we drive the screws from the outer side, once all the lock nuts are secured, we can put the dash back together now that we have everything back together with the pedestal base and backplate installed. We can attach the rest of the pedestal by putting it on and tightening the wing nut, and we also want to adjust the other side for the next step by tightening the second wing nut.
The next step of the installation is attaching the four prong plate to the pedestal. The first thing we're going to do is grab a Philips screwdriver and loosen the center screw until the backplate comes off. Now you want to grab the shorter set of included machine screws and the second set of block nuts we're going to use those to attach the baseplate to the pedestal face now that we have the nut started, we're going to use the same seven millimeter, wrench and screwdriver to tighten these down with the baseplate installed. We can reattach the four prong plate using the same center screw. We used to take it apart before now that everything's installed, we can use the wing nuts to move the pedestal, and we can tilt and rotate the four prong base for easy operation.
Now, let's prepare the device to prepare the device. The first step is to install the four prong adapter plate into the back of the outer box universe case. It should easily fit into the grooves that are already part of the case make sure that the narrow part of the plate holes are pointed toward the top of the device to be mounted. The second step is simply fitting the vise into the case. Now that we have the four prong adapter plate installed in our universe case.
We can go ahead and mount it on our pedestal mount. Then we can easily rotate and reposition the device. That concludes the installation of bundle number one: zero, zero, nine one six. We hope this video has helped have a great day.
Source : ProClip USA
Phones In This Article
Related Articles
Comments are disabled
Latest Articles
