HTC Desire 10 Pro Screen Repair, Teardown and Reassemble - Fixez.com By Fixez.com

HTC Desire 10 pro screen repair, tear down and reassemble warning you're performing this repair at your own risk. We claim no responsibility for any damages that might occur to perform this DIY repair. You will need a plastic triangle: opening tool, nylon, spider, SIM card ejection tool, fine tip curved tweezers precision, knife set premium, 2, millimeter, red adhesive, roll multipurpose heat gun, Phillips screwdriver, playing cards, power down your HTC Desire 10, pro phone eject the SIM card and micros card tray with the precision knife create enough space to insert a triangle opening tool work around the HTC phone and release the clip. Securing the plastic rear cover in place once the HTC Desire 10 Pro rear panel is dislodged, use the spider to detach the fingerprint sensor and remove the back cover from the phone. Remove the following: 19 Phillips screws pry up the exterior mid-frame that protects the HTC Desire 10 pro motherboard use the tweezers to separate the fingerprint sensor from the exterior mid-frame and then peel off the piece of tape. You extract the HTC loudspeaker and intend a module from the bottom of the smartphone, disconnect the HTC Desire 10 pro battery from the motherboard locate the pull to remove adhesive tab on the bottom of the battery.

Slowly, pull the tab up and away from the HTC phone to free the 3.8 5 volt 3000 William per hour desire 10 pro battery detach the bevy of cables from the HTC Desire 10 pro motherboard remove the following: 2 Phillips screws remove the motherboard from the HTC phone, be mindful of the vibrator as it is soldered to the board and lightly adhered to the mid-frame. Remove the impressive 13 megapixel HTC Desire 10 pro from facing selfie camera, extricate the 20 megapixel HTC Desire 10 pro rear-facing camera from the motherboard pry, the 3.5 millimeter stereo audio jack up from the mid-frame tweezer, the HTC Desire 10 Pro earpiece speaker out of the chassis, disconnect the three cables from the daughter board sludge, the HTC Desire 10 Pro daughter board up from the mid-frame. It includes the microUSB connector, a microphone spring contacts and some control hardware carefully. Remove the fragile power and volume buttons cable from the side of the interior, mid-frame, the FHD 5.5 inch, HTC Desire 10 pro display assembly is glued on solidly apply heat to soften the adhesive, use the precision knife to create enough space to insert a playing card, use the playing card to slice through the sticky adhesive, take your time and apply additional heat as needed once you slice through the adhesive, be mindful of the display cable when decoupling the HTC Desire 10 probe screen from the frame, all the replacing parts and repair tools used in the video are available at wwe. com.

Don't forget to subscribe to our YouTube channel like us on Facebook and follow us on Twitter, make sure to take a look at our other DIY smartphone and tablet repair tutorials. You.

Source : Fixez.com