HUAWEI WATCH GT2 46 mm Latona Disassembly and Assembly Video Tutorial By EASY FIRMWARE

Prepare the required tools, our off the device, use your fingers to loosen the spring bars to the straps. Remove the straps align the spring bar on the long strap with the holes at the bottom of the watch face and install the long strap align the spring bar on the short strap with the holes on the top of the watch face and install the short strap use a hexagon screwdriver to remove the four screws from the rear cover use the plastic spider to pry out the rear cover at the speaker position. Slowly turn over the rear cover by 90 degrees, use the Philips screwdriver to remove the 2 screws from the heart rate sensor: FPC B, 2, B, connector steel sheet use flat, tipped metal tweezers to remove the heart rate sensor. FPC B 2, B, connector steel sheet use the B 2 B connector removal tool to unfasten the heart rate sensor, FPC B, 2, B connector then remove the rear cover, use the B to B connector removal tool to unfasten the main BBC B to B connector side button, speaker, FPC, B to B connector, use the spider to pry out and remove the sub or use plastic tweezers to separate the side. Button speaker FPC from the PCB a use: the B to B connector removal tool to unfasten the TP FPC B to B connector LCD FPC B to B connector, use the Philips screwdriver to remove the three screws on the PCB; a use plastic tweezers to pry out and remove the PCB a use plastic tweezers to remove the water-resistant ring from the front cover assembly align the PCB a with the for locating pins on the front cover assembly and insert it in place, use the Philips screwdriver to tighten the three screws on the PCB; a fasted: the TPF PCB to B connector, an LCD FPC B to B connector on the PCB, an attachment the side button speaker FPC to the PCB, an installation the LCD FPC B to B connector steel sheet, insert the sub board into the corresponding slot on the PCB, a fasted, the main FPC B to B connector and side buttons, speaker, FB, CB to B connector on the sub board, insert a new water-resistant ring in the groove fasten. The heart rate sensor f, PCB to B connector install the hardware sensor, FPC B to B connector steel sheet, use the Philips screwdriver to tighten the two screws on the steel sheet.

Install the rear cover on the front cover assembly use the Phillips screwdriver to tighten the four screws on the rear cover, ensure that the device can start up properly. You.

Source : EASY FIRMWARE